Cannot grab Config from bk7231N

[n-oersch]

I've read the flash of my Beken CBU and tried to read the config via UPK2ESPHome, which resulted in this error:

W: Block by ID 0 does not exist, returning empty
W: Block by ID 0 does not exist, returning empty
W: Block by ID 0 does not exist, returning empty
W: Block by ID 0 does not exist, returning empty
E: AttributeError: 'str' object has no attribute 'get'
E: |-- File "ltchiptool\gui\utils.py", line 25, in <lambda>
E: |-- File "ltchiptool\gui\base\panel.py", line 62, in OnIdle
E: |-- File "ltctplugin\upk2esphome\gui.py", line 176, in OnUpdate
E: |-- File "ltctplugin\upk2esphome\gui.py", line 494, in last_result
E: |-- File "upk2esphome\config.py", line 145, in data_device

Flashing ESPHome Kickstart did work and a Access Point was created, but the Website only lets me set up the Access Point and when using Grab from ESPHome-Kickstart i get the incomplete response error.

Sadly re-flashing the previously dumped .bin did not really work, as the LED Strip now doesn't light up at all, but the kickstart access point isn't created anymore.

(I did dump multiple times for safety, but all dumps have the same results)

[Cossid]

Not all dumps have stored configuration data. That error usually corresponds to TuyaOS 3 devices, so make sure you're using the latest version of LTChipTool/UPK2ESPHome.

If the device is RGB/RGBW/RGBWW you should be able to identify PWM pins with Kickstart's pinscan. If it RGBIC, then it will probably be beken_spi_led_strip on P16