It works fine with the picofido 6.6 firmware, but the configured will fail, after all, the support list only starts from firmware 7.0.
I get the same result using your customised version 7.4.2. At the moment, I'm using this RP2040 development board.
https://www.nologo.tech/product/raspberrypie/RP2040/rp2040usb/rp2040_usb1.html
After writing the firmware and plugging it back in, a picokeys prompt will pop up in the bottom right corner, which may not be a hardware issue. But picoforge will temporarily become unresponsive, then after about two minutes it can be detected, and the hardware identification information is all normal. When entering the settings interface and clicking apply, it keeps loading and then shows this error.
I once tested with Waveshare RP2040 Zero, and whether it was picofido 7.6/8.0 or your 7.4.2, it could successfully detect and configure it.
Yes, the weird thing is that the latest 8.0 isn't officially supported, but it can actually be configured successfully.
These words might sound a bit strange, my English isn't very good so I used a translator, hope you understand.
Hope to get your reply and have the bug fixed, thanks.
It works fine with the picofido 6.6 firmware, but the configured will fail, after all, the support list only starts from firmware 7.0.
I get the same result using your customised version 7.4.2. At the moment, I'm using this RP2040 development board.
https://www.nologo.tech/product/raspberrypie/RP2040/rp2040usb/rp2040_usb1.html
After writing the firmware and plugging it back in, a picokeys prompt will pop up in the bottom right corner, which may not be a hardware issue. But picoforge will temporarily become unresponsive, then after about two minutes it can be detected, and the hardware identification information is all normal. When entering the settings interface and clicking apply, it keeps loading and then shows this error.
I once tested with Waveshare RP2040 Zero, and whether it was picofido 7.6/8.0 or your 7.4.2, it could successfully detect and configure it.
Yes, the weird thing is that the latest 8.0 isn't officially supported, but it can actually be configured successfully.
These words might sound a bit strange, my English isn't very good so I used a translator, hope you understand.
Hope to get your reply and have the bug fixed, thanks.