57-68mm ball (50-60mm with spacers) not compatible with original bottom

[gustavo-etal]

Anyone with the same issue in which this mod does not fit the original bottom, either the top or bottom rows, do not click once the case is closed

[efogdev]

Hey, could you please elaborate? What do you mean by "do not click"? Can you join the parts together and screw them down? Photos will be helpful too.

[Magascorada]

This is an issue across all Ploopy Adept prints. I'd suggest backing out all four screws a few turns each and then testing the buttons. Tightening each one a quarter turn and then testing again.

[efogdev]

@Magascorada I remember you saying something about adding a washer for every screw

[Magascorada]

Yeah, I had some small M2 washers that I used to great success! I'd recommend trying that out as well once you can isolate the issue down to one corner that is causing the issue.

[gustavo-etal]

Got it, here is what I added to make it work

[efogdev]

Glad you got it working and thanks for the feedback!